^----- Nice! Much appreciated!

Anyone tried tackling a Chicago Coin bowling pin for a ball bowler?

Two years have elapsed, how about now? I see someone posted a United pin on Thingiverse... is that even _the_ place to look anymore, if it ever was? As you can tell I never really got very deep into the hobby.

Speaking of speaker adaptor plates, has anyone made a Spike2 mounting adaptor for even larger 6.5" speakers?

I do realize they couldn’t be centered, they'd have to overhang on the inside, but I picked up these spanking new Duals at the thrift store for so cheap that I just have to try. Four for $15, or $3.75 each!

I'm a babe in the woods on the modeling end, but I will have to finally dive in if it hasn't been done already!

Heck, you're supposed to attend to your freakin' toaster!

I am trying to get the Diamond Jack I bought 13 years ago spiffed up and working, finally.

Holding me back is the fact that on the Roto Target, the card faces all have the paint deeply worn through to the metal at ball height, to the point where the metal is grooved, making me nervous that the stickers I bought to cover this flaw will not stay stuck.

I was thinking maybe 3D printing a frame for each card that would clip over each target and sticker would preclude them falling off.

So, has anyone already done anything along these lines? No luck searching... Thanks in advance.